Reference Commands > K > Kanal > Place nipple Heating

With this function, a branch can be connected to a ductwork laterally.

Branches can be rectangular or round. The cross section can be manually entered or taken from the duct tables.

Access to the command over:

AutoCAD/BricsCAD	Allplan
Commandline: _KANALSTUTZEN Assistant: \| Heating construction\|	Toolbar: Heating \| Heating Design \|

AutoCAD/BricsCAD

Allplan

Commandline: _KANALSTUTZEN

Assistant: | Heating construction|

Toolbar: Heating | Heating Design |

Stutzen_re

Option	Description
Dimensions	Rectangular: Tells the section of a rectangular pipe. Round: Tells the sections of a round pipe.
Distance	All values can be inserted, positive or negative. "0" is conform to the middle of the duct. The values are shown in the graphic as preview. a - Is the displacement of the nipple along the duct-width (A=duct-width as in norm). b - Is the displacement of the nipple along the duct-height (B=duct-height as in norm). L - Is the displacement of the nipple along the duct-length (L=duct-length as in norm).
Rotation	Shows the new direction of construction in degrees. This function turns the direction of a nipple on a rectangular duct over this both buttons according to the four main-directions (up, down, left und right). If setting a nipple onto round ducts the new direction can be inserted free or over the buttons as told above; or over the buttons in any direction.
Attach duct with length	The duct-length can be optionally entered.