Access to the command over:

Command line: _WANDDEF

Assistant: | Building physics|

Toolbar: General | Room Schedule |

Search after

You can search components after:

...copy walls from other projects.

...copy asset walls from EneV...

...opens settings for this Dialogue.

Navigator

All walls in the project are listed here.

By right-clicking on a wall you can:

Component type

Defines the wall type according to the Norm (exterior wall, interior wall, etc.).

e...exterior component

b...interior component

g...component to ground

u...component to unheated

Temperature and relative humidity

These fields are necessary for the graphic display of each wall.

The exterior temperature can be found in the norm.

U-values

U-value according to the layer-composition.

Composite walls can be calculated here.

Layer composition

Defines the material built-up of a wall (exter. -> inter.)

The temperature and water vaporisation (Glaser-diagram) development is shown in the diagram.

By right-clicking on a buit-up layer you can:

Print

To print a calculation form with wall built-ups, temperature and water vaporisation development, select "Print".

BPHDB

Building physics data can be loaded from the internet.