|
<< Click to Display Table of Contents >> Place nipple Sanitary |
  
|
|
<< Click to Display Table of Contents >> Place nipple Sanitary |
|
With this function, a branch can be connected to a ductwork laterally.
Branches can be rectangular or round. The cross section can be manually entered or taken from the duct tables.
Command line: _KANALSTUTZEN
Assistant: 
| Sanitary Construction | 
The Dialogue opens:
Option |
Description |
|---|---|
Dimensions |
Rectangular - Tells the section of a rectangular duct.
Round - Tells the sections of a round duct. |
Distance |
All values can be inserted, positive or negative. "0" is conform to the middle of the duct. The values are shown in the graphic as preview.
a - Is the displacement of the nipple along the duct-width (A=duct-width as in norm).
b - Is the displacement of the nipple along the duct-height (B=duct-height as in norm).
L - Is the displacement of the nipple along the duct-length (L=duct-length as in norm). |
Rotation |
Shows the new direction of construction in degrees.
This function turns the direction of a nipple on a rectangular duct over this both buttons according to the four main-directions (up, down, left und right). If setting a nipple onto round ducts the new direction can be inserted free or over the buttons as told above; or over the buttons in any direction. |
Attach duct with length
|
The duct-length can be optionally entered. |