Starting Values - Electro Construction

Cable line material

The material for construction of electrical cable lines is given. (manufacturer, type)

Also availabe are flexible and standing seam ducts.

... Button to edit the Material management.

Cross Section

Shows the desired cross section from start point of construction.

When you continue from an existing fitting it's cross section will be overtaken automatically.

Height

The height is the Absolute-Height of the cable line in relation to building.

You can enter each the upper edge, the middle and the sub edge of the duct.

The other both values will be calculated through the duct dimensions.

Direction

The direction shows the construction direction according to the 1. duct point.

The direction of both picked duct points will be shown.

Any desired angle can be used.

The main directions are:

horizontal:

000° - on the screen to the right

090° - on the screen above

180° - on the screen to the left

270° - on the screen below

vertical:

000° - horizontal construction

090° - vertical construction above

-90° - vertical construction below

Tilted:

Ductwork can be tilted, that is turned over it's length axis.

e.g.: Cross section of a unit in roof slope:

Position

The position describes the ducts direction along a wall, when the both duct points lye on a line or wall at scanning.

left:

The cable line will be placed on the left of the line.

centric:

The cable line will be placed on the center line.

right:

The cable line will be placed on the right of the line.

Distance:

Defines the distance between the cable line and the line with the settings left or right.

Functional fields

(Place, Continuous construction, Cancel)

See chapter "Functional fields"