Duct

By activating this function, the last part becomes a duct.

End cap

By activating this function, the last part becomes an end cap.

End cap with flange

By activating this function, the last part becomes an end cap with flange.

Volume flow

This function activates the Volume Flow Calculation for ductwork cross-sections.

Cross Section

The cross section can be manually entered or taken from the Volume Flow Calculation.

Position / Special Fitting

This function is used to construct special fittings (several fittings in same framework) in a ductwork.

Special fitting:

Activates the function special fitting.

Distance:

The both distance inputs are responsible for the horizontal and the vertical distance from positioning fields.

Position:

left        flush with left edge

centric   center along horizontal

right      flush with right edge

top        flush with top edge

centric   center along vertical

below    flush with bottom edge

Selected length

Rest length

Std. length

See chapter "Length"

Functional fields

(Place, Continuous construction, Cancel)

See chapter "Functional fields"