Easyline Starting-point Sparger

<< Click to Display Table of Contents >>

Navigation:  Reference Commands > S > Set >

Easyline Starting-point Sparger

 Previous pageReturn to chapter overviewNext page

 

Function to place a sparger starting-point for the Easyline-System.

These start points contain all the necessary values for calculating a pipework system.

 

                                Access to the command over:

   

AutoCAD/BricsCAD

Allplan

 

Command line: _SETAP_SPR

 

Assistant: spr-small | Sparger Easyline | ap_spr

 

Toolbar: Sprinkler | Sprinkler |ap_spr

 

 

 

 

AP_Sprinkler

 

 

Dialogue-Options

 

Option

 

Description

New Layer for system

Checkbox_off

At deactivated Checkbox: pipework is set in the active layer.

 

Checkbox_on

At activated Checkbox: an new layer can be set for the pipework to be calculated.

The layer can be selected and modified from the layer-selection with its description.

The color can also be modified.

 

The settings Trade Definitions are valid.

Material

The material and the minimum diameter of the generated pipework can be selected.

All heating materials stored in the pipe tables can be used.

Sparger table

Max. Velocity:

 

min. Diameter for main line:

 

max. Diameter for standard line:

 

Transition with saddle clamps instead of t-pieces:

Position

By activating 'pick height in drawing', the Easyline-Start point is set on picked point. When deactivating this function, a new height can be entered.