X-piece

Draws a symmetrical x-piece in through type.

Alignment

Side/Center:

Side    ... Bow ends with back edge at 2nd system-point.

Center... Bow ends centric at 2nd system-point.

Rotation:

Shows the construction direction in degrees.

The direction can be manually rotated for rectangular ducts with these buttons in four main directions (up, down, left, right).

Volume flow

This function activates the Volume Flow Calculation ductwork cross sections.

Cross Sections

b:  

Shows the start width which had been entered in the Starting Values.

d/h:

Here you can enter the end cross- sections of the construction fitting.

The final cross section of constructed fittings will be entered.

The cross section 'd' is for the through-fitting, cross section 'h' for the branch. This cross sections can also be taken from the Volume Flow Calculation.

Internal Dimensions

Here you can correct the internal dimensions and the radii of the x-piece.

As standard the program values will be used to get a symetrical or asymetrical x-piece according to selection.

Continuation

Here you choose the branch duct, where you want to connect.

Selected length

Rest length

Std. length

See chapter "Length"

Functional fields

(Place, Continuous construction, Cancel)

See chapter "Functional fields"