Straight Tee

Draws a symmetrical tee.

Mitered Tee

Draws an asymmetrical tee.

Alignment

Side/Center:

Side    ... Bow ends with back edge at 2nd system-point.

Center... Bow ends centric at 2nd system-point.

Rotation:

Shows the construction direction in degrees.

The direction can be manually rotated for rectangular ducts with these buttons in four main directions (up, down, left, right).

With this function you can change between a through-fitting tee and a cross fitting tee.

Volume flow

This function activates the Volume Flow Calculation ductwork cross sections.

Cross sections

a:  

The start cross section (a/b) of the fitting entered in the Starting Values will be shown.

d/h:

The end cross sections for the constructing fitting will be entered here.

The cross section 'd' corresponds the passage, the cross section h the branch.

The cross sections can also be determined over the Volume Flow Calculation and can be overtaken.

Internal dimensions

Here you can correct the internal dimensions and the radii of the tee.

As standard the program values will be used to get a symetrical or asymetrical tee according to selection.

Selected length

Rest length

Std. length

See chapter "Length"

Functional fields

(Place, Continuous construction, Cancel)

See chapter "Functional fields"