Easyline Load-point Fancoil

                                Access to the command over:

Command line:: _SETLP_F

Assistent: | Fancoil |

Component

Here you can choose the component.

Opens the function Block selection.

Room no:

You can select a roomnumber here.

Heating

For this component valves and connection parameters for fancoils can be set.

Heating system: Choose the heating system for the calculation.

Heat Efficiency / Flow rate: The performance of the load-point is set here.

Zeta-value / Pressure loss: Edit your values here.

Cooling

For this component valves and connection parameters for fancoils can be set.

Cooling system: Choose the cooling system for the calculation.

Performance / Flow rate: The performance of the load-point is set here.

Zeta-value / Pressure loss: Edit your values here.

Position

If the function Select height on screen is activated, the Easyline load-point will be drawn on the height that is picked on the screen.

If this function is not activated you can insert a height here.